How to use your Personal Sauna
So Easy to use
The Personal Sauna can be set up anywhere within 3 metres of a 13amp power point, simply unfold, fill the steamer with tap water to the clearly marked level and switch on.

Step one
Step One After removing your new sauna from the box, open up the tent by pulling open front ends towards you.
|

Step Two
Step Two Inside the tent are 2 frames pull both out towards you and make sure they are pulled tight into both corners of the tent.
|

Step Three
Step Three Next pull the seat down and at the same time pull the leg bar up and check that the seat section is inside the left and right hand sections of the frame.
|

Step Four
Step Four Pour 2 litres of warm water into your empty Steam Generator. This will give you the approximate steam time of 30 minutes, (if you want more time in the tent, add more water to the Steam Generator). Connect the Steam Generator to the mains using the 3M cable and safety socket provided. Then feed the Steam tube through the vent at the back of the Personal Sauna.
|

Step Five
Step Five We recommend that you put a towel on the floor of the tent, to absorb the small amount of water which may accumulate on the floor of the tent. So simple and now you're ready for a relaxing Sauna.
|